Westminster Electrician GuideIndependent homeowner guide · Westminster, Colorado

Older-home wiring in Westminster, CO

About a third of Westminster's homes were built before 1980. If yours is one of them, two questions come up most: is there aluminum branch wiring, and is the wiring adequate for today's loads?

Updated November 18, 2026 · Researched from City of Westminster, Colorado DORA and utility sources

On this page
  1. How old is Westminster's housing?
  2. Aluminum branch wiring
  3. When rewiring makes sense
  4. Published cost ranges (national)
  5. The permit in Westminster
  6. Frequently asked questions

How old is Westminster's housing?

From the Census Bureau's ACS 2020-2024 estimates for the city (Census Reporter):

Year built Housing units
1939 or earlier 395
1940 to 1949 319
1950 to 1959 3,126
1960 to 1969 2,540
1970 to 1979 10,624
1980 to 1989 11,408
1990 or later 22,059
Total 50,471

That is 17,004 units, about 34%, built before 1980.

Aluminum branch wiring

The U.S. Consumer Product Safety Commission says homes built before 1965 are unlikely to have aluminum branch circuit wiring, and that aluminum cables were installed in new homes, additions and rewiring between 1965 and the mid-1970s. (CPSC Pub. 516) It reports research for the CPSC finding that homes built before 1972 and wired with aluminum were 55 times more likely to have connections reach "Fire Hazard Conditions" than homes wired with copper. The hazard is at the connections: outlets, switches and splices. (CPSC Pub. 516)

With 10,624 Westminster units built in the 1970s, this is worth checking if your home is from that decade. The CPSC warns that failing aluminum connections "seldom provide easily detected warning signs," but lists hot-to-the-touch faceplates, flickering lights, circuits that don't work and the smell of burning plastic at outlets or switches. It recommends either replacing the aluminum branch wiring with copper or a permanent repair of the connections, and strongly recommends a qualified electrician for the work. (CPSC Pub. 516)

When rewiring makes sense

Angi's national rewiring guide says homes from the 1940s and 1950s often have 60-amp service, which it calls insufficient for modern devices. (Angi, rewiring) Rewiring is also an opportunity to add GFCI and AFCI protection and outlets where you need them.

Published cost ranges (national)

Angi puts rewiring at $2 to $4 per square foot, materials and labor included, and lists permits at $75 to $150 and inspections at $100 to $125 nationally. (Angi, rewiring)

Home size National range
1,000 sq ft $2,000 to $4,000
1,500 sq ft $3,000 to $6,000
2,000 sq ft $4,000 to $8,000
2,500 sq ft $5,000 to $10,000

The permit in Westminster

Rewiring is not on the City code's short list of permit-exempt electrical work, so it needs a permit. (§ 11-9-3) For a job valued at $8,000, the City's 2026 fee schedule works out as follows (schedule arithmetic, not a quote). (Fee schedule)

Example: job valued at $8,000
Line itemAmount
Building permit fee (valuation table)$130.65
Plan review fee (65% of permit fee)$84.92
Electric permit trade fee (15% of permit fee)$19.60
Electric plan review trade fee (15% of plan review fee)$12.74
Estimated use tax (4.25% of 50% of valuation)$170.00
Total if every line applies$417.91

Rewiring usually means opening walls. Ask whether drywall repair is in the quote; Angi lists opening and repairing walls at $4 to $8 per square foot nationally. (Angi, rewiring)

Frequently asked questions

Do Westminster homes have aluminum wiring?

Some may. The CPSC says aluminum branch wiring was installed between 1965 and the mid-1970s, and Westminster has 10,624 housing units built in the 1970s. Only an inspection of your home can tell.

Is aluminum wiring dangerous?

The CPSC reports that pre-1972 homes wired with aluminum were 55 times more likely to have connections reach fire hazard conditions than copper-wired homes. The risk is at connections, and the CPSC describes permanent repair methods.

How much does it cost to rewire a house?

Angi's national range is $2 to $4 per square foot, so about $4,000 to $8,000 for 2,000 square feet, plus permits and wall repair.

Sources

Checked November 18, 2026.

  1. Census Reporter, Westminster, CO (ACS 2020-2024 5-year)
  2. U.S. CPSC, Repairing Aluminum Wiring (Pub. 516)
  3. Angi, Cost to Rewire a House (national)
  4. Westminster Municipal Code Title XI, Ch. 9, § 11-9-3 (Zoneomics compilation)
  5. City of Westminster, Building Division Fee Schedule (effective Jan. 1, 2026)